The Delta-Nit Pad begins the finishing process after dyeing, bleaching, or scouring of circular knit fabrics. The Delta-Nit Pad processes either single or double strands of fabric and is available in either a two- or four-roll setup. Designed to be operated by only one person, the Delta-Nit Pad handles detwisting, spreading, extracting and chemical application.
Electricity: 25 kW, 3 phase, 50/60 Hz
Air: 80 psi (414 kPa), Consumption Neg.
Water: Neg.
Solution Inlet: 1 inch STT Pipe (2.54 cm)
Speed: 0-110 yard/min (0-100 m/m)
Working Width: 40″ Model Single Strand 7-36 inch (18-91 cm)
50″ Model Single Strand 7-46 inch (18-116 cm)
60″ Model Single Strand 7-56 inch (18-142 cm)
60″ Model Single Double Strand 7-28 inch (18-71 cm)
Weight: 5,500 lbs. (2,500 kg)
Navis TubeTex designed the CQC System to be supervisor driven, so only designated personnel can access recipes, including valve operations, set points and allowable tolerances. Supervisory-only access means product consistency is 100% assured. Once the function and timing for CQC recipes is established, an operator can use the Delta-Nit Pad’s control panel to start and run the set chemical application process.
The savings our customers see using the CQC System varies depending on the chemicals used, but 15% to 30% in run-time savings is typical. In addition, the Navis TubeTex CQC System captures chemicals normally lost during changeovers and color changes in standard uncontrolled systems. The captured chemical mix is metered out at the correct concentration with little – or no – loss. Standard large-mix-tank operations start at higher concentrations than required then drop until the solution reaches equilibrium, which can change based on each material’s width, weight, fiber and construction. The CQC System, on the other hand, eliminates waste by delivering consistent, efficient chemical application every time.
The detwisting process begins at the hydraulic-powered turntable which is installed in the floor at the front of the Delta-Nit Pad. The heavy duty turntable uses an inverter controlled soft starting pump that minimizes the stress on the turntable. Our optional power-driven cloth lifter, torque compensator and automatic detwisting sensor removes the twist from dyeing and carries the fabric tension-free to the Delta-Nit Pad.
